This clock represents one of the most complex challenges I have faced: making a skeleton regulator fitted with a detent escapement, one of the most delicate and sophisticated escapements in precision clockmaking.
The detent escapement: a challenge without construction plans
The detent escapement is traditionally used in marine chronometers, where precision is essential. Unlike anchor escapements, the detent gives the pendulum an impulse in one direction only, minimising interference with the regularity of the oscillation. This feature makes it theoretically more precise, but also extremely delicate to build and set up.
The main difficulty in my case was the lack of construction plans or of a specific reference geometry for this type of escapement applied to a pendulum clock (the detent is more common in balance-wheel chronometers). I had to proceed by trial and error, trying different configurations and impulse angles. At one point, I confess, I even thought of giving up because of the continual failures: every small variation in the geometry of the detent or in the weight of the pendulum could completely compromise the operation.
Click every picture to enlarge it
The half-second pendulum
For this clock I chose a half-second pendulum (each swing lasts 0.5 seconds). This choice, while making the project more complex, offers the advantage of a fast, lively tick, and makes it easier to observe any irregularities in the working of the escapement.
The results: a true regulator
The final result of testing this clock's ability to keep correct time was quite satisfactory (and I say it with great satisfaction), so much so that it can be considered a true regulator. The photographs show the average duration of 10 consecutive swings and the average duration of the following 10 swings, demonstrating the constancy and reliability of the detent escapement once correctly adjusted.
average time for 10 swingsaverage time for the following swings
For a full description of the construction and of the numerous attempts that led to success, I invite you to visit the dedicated pages of the forum dedicated to pendulum clocks (in Italian).
Reproduction of part or all of the contents of any of the pages of this site is prohibited except to the extent permitted below.
These pages may be downloaded onto a hard disk or printed for your personal use without alterations. This copyright notice and the source must appear on each copy. These pages may not be included in any other work or publication, or be distributed or copied for any commercial purpose except with the explicit permission of the author.