Italiano

Clockmaker.it home
Clockmaker.it - the home of antique clocks

Congreve clock
(#63)

For details and an account of the construction of this clock, I invite you to visit this page of my forum (in Italian).

(click each image to enlarge it)

Clocks built on the prototype of the one made by Sir William Congreve commonly have the tilting table between four small columns that, in turn, support the movement, as in my two previous examples (#3 and #26).

In making this new Congreve clock I wanted to favour the view of the tilting table, placing it fully on display in the upper part of the structure, to allow a better observation of this fascinating mechanism in action.

The principle of the Congreve clock

The Congreve clock, patented by Sir William Congreve in 1808, is one of the most fascinating clockwork mechanisms ever conceived. In place of the traditional pendulum or balance wheel, it uses a metal ball that rolls back and forth on a zigzag inclined plane.

Its working is hypnotic to watch: the ball rolls along a zigzag groove on the tilted table. When it reaches the end, its weight triggers a mechanism that tips the whole table over, reversing the slope. The ball then starts rolling in the opposite direction. This cyclical and regular movement of the little ball replaces the oscillation of the pendulum as the regulator of time.

The time the ball takes to travel the whole length of the table is constant and predictable, allowing an accurate measurement of time. The energy needed to tip the table comes from the clock's mainspring.

Congreve clock no. 63 Rear view of the Congreve clock no. 63

An innovative design

The choice to place the tilting table in the upper part, fully visible, is not just aesthetic: it allows you to fully appreciate the beauty of this unusual mechanism, turning the clock into a true object of contemplation as well as of timekeeping. The hypnotic movement of the ball rolling back and forth thus becomes the visual protagonist of the whole clock.

This is my third Congreve clock, and every time I build one I remain fascinated by the ingenuity of this mechanism, so different from any other type of clock.

All the construction details are documented in the pages of my forum (in Italian).

Rear view of the Congreve clock (2) Side view of the Congreve clock Side view of the Congreve clock (2) The little ball of the Congreve clock The tilting table of the Congreve clock The wooden base of the Congreve clock The arms of the tilting table The Congreve clock under its glass dome

all my clocks

Reproduction of part or all of the contents of any of the pages of this site is prohibited except to the extent permitted below.
These pages may be downloaded onto a hard disk or printed for your personal use without alterations. This copyright notice and the source must appear on each copy. These pages may not be included in any other work or publication, or be distributed or copied for any commercial purpose except with the explicit permission of the author.